I assembled the wings.

Even if the fit is good, be sure to check that every part goes where it is supposed to. Some of them needs to be fit under the wing surface. I’ll wait with the lights until later, except for the three lights on the wing tip, which I nearly missed to put in place.

Then I started with the engine. Removing all the nubs and cleaning up took a while.

I read on a build that there was some issue with the push rod and after checking pics I realised that HK had made twice as many. There is as I understand it only two per cylinder.
I removed the parts for the other engine and will use 2 of the cleaned up push rod rings, and 2 rings where I’ll remove the push rods.
The reason is that the assembly will need all rings to fit later.

I’ll sort that next time a the desk!