While checking the body again I noticed something was a bit off. So I cut loose the tail lights and tried to put them in place. They didn’t fit very well.

There’s quite a gap in both the top and the bottom. Turns out, after checking the net, that the body I have is for a 1969 Plymoth and the tail lights is for a 1968 one.

I added some plastic sheet to the inside and a few strips on the top and bottom as well.
I looks better but maybe not perfect!

I glued together the engine room, added the engine and radiator.

I also continued with the underside of the chassie.

In order to have those intakes I had to cut open the hood, which I so carefully had filled on the underside.

Test fit of the body and hood on the chassie.

Next I’ll go over the body with a new layer of primer and if it checks out okey I’ll start painting the body.